12PSB-NT2000A噴油泵試驗臺

精達動力機械制造廠為大家帶來關于使用12PSB-NT2000A噴油泵試驗臺須知的詳細介紹，并圖文并茂的給大家展示了高壓共軌噴油器試驗臺的使用，預知詳情請點擊液壓泵試驗臺廠家的官方網站進行查詢吧。

12PSB系列噴油泵試驗臺的出廠標準：

1、 下機殼部分無劃痕，凹陷，色差等明顯質量缺陷

2、 工作臺中心線與邊框平行，無明顯偏差

3、 電機中心與工作臺高度為125±0.05mm，左右對稱為±0.05mm

4、 電機與工作臺，工作臺與下機殼連接螺栓緊固，有無彈平墊

5、 刻度盤與試驗臺殼體之間距離為15mm,方便安裝轉速傳感器。

6、 萬向節與刻度盤連接緊固，不得刮擦防護罩

7、 供油葉片泵泵與供油電機連接，無間隙轉動，緊固螺母旋緊

8、 噴油泵試驗臺萬向節與聯軸器加緊后，共軌泵不得有明顯擺動。

Factory standard of 12psb series fuel injection pump test bench:

1. The lower casing is free of obvious quality defects such as scratches, dents, color differences, etc

2. The center line of the workbench is parallel to the frame without obvious deviation

3. The height between the motor center and the workbench is 125 ± 0.05mm, and the left-right symmetry is ± 0.05mm

4. The connecting bolts between the motor and the workbench, and between the workbench and the lower casing are fastened, and whether there is an elastic flat pad

5. The distance between the dial and the test bench shell is 15mm, which is convenient for installing the speed sensor.

6. The universal joint is firmly connected with the dial, and the protective cover shall not be scratched

7. The oil supply vane pump is connected with the oil supply motor, rotates without clearance, and the fastening nut is tightened

8. After the universal joint and coupling of the fuel injection pump test bench are tightened, the common rail pump shall not swing significantly.

內容由百度翻譯，僅供參考。